Adjusting The Blade Length - GRAPHTEC FCX4000 SERIES User Manual

Adjusting the Blade Length
Blade length needs to be adjusted to perform optimal cut. Perform few test cuts and set the optimal blade length.
CAUTION
•
To avoid bodily injury, handle cutter blades with care.
•
It may result in damaging the cutter blade or the writing panel if the blade is extended too much. Make sure the blade
length is set less than the thickness of the media.
Please always perform "test cut" to adjust the blade length.
Supplement
•
See "Running Cutting Tests" for cutting tests.
•
See "Adjust the Blade Length Manually" for method to manually adjust the blade length.
•
If a thin media such as a film is used, use the supplied magnifier to adjust it.
Adjust the blade length by turning the blade-length adjustment knob. Turn the knob in direction "A" to extend the
blade, or in direction "B" to retract the blade.
For PHP35-CB09-HS/PHP35-CB15-HS, when the knob is turned the distance of one scale unit, the cutter blade
moves approximately 0.1 mm. When the knob is given one full turn, the cutter blade moves 0.5 mm.
Cutter blade moves
approximately 0.1 mm turning
one scale unit
Cutter blade moves
approximately 0.1 mm turning
one scale unit
PHP33-CB09N-HS/PHP33-CB15N-HS
Scale
PHP35-CB09-HS/PHP35-CB15-HS
Scale
Scale
Scale
2-4