Move Away the Tool Carriage
is possible to move the tool carriage 100 mm toward upper right. It makes it easier to confirm the cutting
It
results if you perform this operation after the cutting is completed.
<For rear loading/roll media>
<For the sheet>
T o the top of
the maximum
cutting area
Operation
Press the [2] key in READY status.
1
T ool carriage will move away.
T o move the tool carriage to the origin point, do following:
Operation
Press the [3] key in READY status.
1
T ool carriage will move to the origin point.
Standby position of the pen
carriage
Position of the pen carriage
T o the bottom of the cutting area
(machine origin point)
Bottom of the operation area
3-5
before moving away
Supplement
T ool carriage will move away to upper right by
continuously performing the same operation.