Functions On Digital Operator/Panel Operator; Connecting The Digital Operator - YASKAWA SGM H Series User Manual

Table of Contents

7 Digital Operator/Panel Operator

7.1 Functions on Digital Operator/Panel Operator

This section describes the basic operations of the digital operator (hereinafter called the digital operator) and the

panel operator (hereinafter called the panel operator) for setting the operating conditions. Set parameters and

JOG operation, and display status using these operators. For the operation of the digital operator (Model: JUSP-

OP02A-2), refer to Σ-II Series SGM H/SGDM Digital Operator Operation Manual (TOE-S800-34).

7.1.1 Connecting the Digital Operator

Two types of digital operators are available. One is a built-in operator that has a panel indicator and switches

located on the front panel of the SERVOPACK. This type of digital operator is also called a panel operator. The

other one is a hand-held operator (JUSP-OP02A-2 digital operator), which can be connected to the

SERVOPACK with connector CN3 of the SERVOPACK.

There is no need to turn OFF the SERVOPACK to connect this hand-held operator to the SERVOPACK. Refer to

the following illustrations to connect the digital operator to the SERVOPACK.

Digital Operator

JUSP-OP02A-2

If the digital operator is connected to the SERVOPACK, the panel operator does not display anything.

Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

A dedicated cable is used to

connect the digital operator

to the SERVOPACK.

Panel Operator