Digital Operator/Panel Operator; Functions On Digital Operator/Panel Operator; Connecting The Digital Operator - YASKAWA E-II Series User Manual

7 Digital Operator/Panel Operator

7.1.1 Connecting the Digital Operator

7.1 Functions on Digital Operator/Panel Operator

This section describes the basic operations of the digital operator (hereinafter called the digital operator) and the
panel operator (hereinafter called the panel operator) for setting the operating conditions. Set parameters and
JOG operation, and display status using these operators. For the operation of the digital operator (model: JUSP-
OP02A-2), refer to Σ-II Series SGM H/SGDH Digital Operator Operation Manual (TOE-S800-34).

7.1.1 Connecting the Digital Operator

Two types of digital operators are available. One is a built-in operator that has a panel indicator and switches
located on the front panel of the SERVOPACK. This type of digital operator is also called a panel operator. The
other one is a hand-held operator (JUSP-OP02A-2 digital operator), which can be connected to the SERVO-
PACK with connector CN3 of the SERVOPACK.
There is no need to turn OFF the SERVOPACK to connect this hand-held operator to the SERVOPACK. Refer to
the following illustrations to connect the digital operator to the SERVOPACK.
IMPORTANT
7-2
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Digital Operator
JUSP-OP02A-2
. . . . .
DIGITAL
SERVOPACK OPERATOR
JUSP-OP02A
ALARM
DSPL
SET
RESET
JOG DATA
SVON ENTER
YASKAWA
A dedicated cable is used to
connect the digital operator
to the SERVOPACK.
If the digital operator is connected to the SERVOPACK, the panel operator does not display anything.
WARNING
5
May cause
electric shock.
Disconnect all power
and wait 5 min.
before servicing.
Use proper
grounding techniques.
Panel Operator
POWER
CN8
BATTERY
CN5
MODE/SET DATA/
CN3
SERVOPACK