Table of Contents
Advertisement
10.5.4 Output Signal Selection
Parameter
Pn510
n. 0
n. 1
n. 2
n. 3
For the factory settings, the pins CN1-25 to CN1-30 are allocated for other output signals. If multiple signals are allocated
to the same output terminal, signals are output with OR logic. To enable only the /PSELA output signal, allocate the other
signals to other output terminals or disable the other signals.
Refer to 7.3.3 Output Circuit Signal Allocation for the allocation of output signals.
Note: After changing the setting, turn OFF the power and ON again to enable the new setting.
10.5.5 Utility Functions
Parameter
No.
Servomotor model is added.
F.
Fn011
Encoder model is added.
E.
Note: Refer to 10.3.1 (1) Applicable Motors and 10.4.2 Adaptation to Single-turn Data Absolute Encoder for
details.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Disabled (The /PSELA signal is not used.）
Outputs the /PSELA signal from the CN1-25, CN1-26 output terminal.
Outputs the /PSELA signal from the CN1-27, CN1-28 output terminal.
Outputs the /PSELA signal from the CN1-29, CN1-30 output terminal.
Contents of Display
10.5 Additional and Improved Parameters
Meaning
: No modification in voltage designation
: Servomotor models
32: SGMCS-
C
33: SGMCS-
D
34: SGMCS-
B
35: SGMCS-
E
36: SGMCS-
L
37: SGMCS-
M
38: SGMCS-
N
: Encoder models
00: Incremental
01: Multiturn data absolute
02: Single-turn data absolute
: No modification in encoder resolution
designation
10
10-21
Advertisement
Table of Contents
Troubleshooting
