Configuring VoIP QoS
Configuring Weighted Fair VoIP Queueing (WFVQ)
Use the voip-queue-delay command to set the maximum query delay. To determine
●
the queue size you currently have, use the show queueing command.
Use the fair-queue-limit command to specify the maximum number of packets that
●
can be queued in the weighted fair queue. The upper and lower limits of this command
depend on the amount of bandwidth configured for the interface.
Note:
This command should generally be used only for troubleshooting.
Note:
Use either the voip-queue or the priority-queue command in interface context to
●
disable WFVQ on an interface, by enabling another queuing mode.
Use the fair-voip-queue command in interface context to re-enable WFVQ on an
●
interface. WFVQ is the recommended queuing mode for interfaces.
Note:
There is no no form of the fair-voip-queue command. If you enter the
Note:
command no fair-voip-queue, it will actually enable WFVQ if WFVQ is not
already enabled.
208 Administration for the Avaya G250 and Avaya G350 Media Gateways