Insert guide bushing -T10071/1- on the
–
camshaft stub.
Position gasket ring over the guide
–
bushing onto the camshaft stub and
remove sleeve.
Press in the gasket ring with pressure
–
bushing -T10071- and screw -T10071/2-
up to the stop.
Proceed as follows for both versions
–
Insert Woodruff key.
Install camshaft sprocket and tighten to
–
100 Nm (use counterholder -MP 1-216-).
Installing and tensioning toothed belt
–
(setting timing)
Removing and installing camshaft
Special tools and workshop equipment required
t
Torque wrench
t
Counterholder -MP 1-216-
Removing
–
Remove top toothed belt guard.
–
Loosen the camshaft sprocket (use counterholder -MP 1-216-).
→
Chapter.
74