Removing And Installing N205 The Camshaft Adjustment Valve 1; Removing And Installing Valve Stem Seal - Skoda Octavia III 2013 Workshop Manual

– Fit guide bushing -T10479/2- with sealing ring -2- centrally on‐
to the camshaft.
– Fix guide bushing with screw -1- for coolant pump driving
wheel onto the camshaft.
– Push sealing ring onto camshaft, unscrew guide bushing.
– Pull sealing ring -2- into the stop using the thrust piece -
T10479/1- and the screw -1- for coolant pump driving wheel.
– Install toothed belt pulley for coolant pump
⇒ "2.5 Removing and installing toothed belt pulley for coolant
pump", page 162 .
3.5 Removing and installing - N205- the
camshaft adjustment valve 1
Removing
– Disconnect plug connection -1-.
– Unscrew screw -2- and remove camshaft control valve 1 -
N205- .
Install
Installation is carried out in the reverse order. When installing,
observe the following:
Note
Renew O-ring.
Tightening torques
Component
Screw for camshaft control valve 1
3.6

Removing and installing valve stem seal

⇒ "3.6.1 Removing and installing valve stem seal with cylinder
head installed", page 119
⇒ "3.6.2 Removing and installing valve stem seal with cylinder
head removed", page 122
3.6.1 Removing and installing valve stem seal
with cylinder head installed
Special tools and workshop equipment required
Octavia III 2013 ➤ , Octavia III 2014 ➤
1.2/63; 77 kW TSI engine - Edition 11.2014
Nm
8 Nm
119
3. Valve gear