Removing And Installing Valves - Skoda FABIA 2000 Workshop Manual

15
Procedure
–
Insert valve into guide. End of valve stem must be
flush with guide.
–
Determine valve rock.
Wear limit
Inlet valve
0.5 mm
Note
♦ If the wear limit is exceeded, repeat measurement
with new valve. If the wear limit is again exceeded - re-
place cylinder head.
♦
If the valve is replaced when carrying out repair work,
use a new valve for the measurement.

Removing and installing valves

Removing
Special tools, test and measuring equipment and
auxiliary items required
♦
Valve supporting plate -MP 1-113-
♦ Valve spring assembly lever -MP 1-114-
♦
Insert for conical spring -MP 1-114/1-
♦ Threaded connector M8x40
–
Fit cylinder head onto the valve supporting plate
- MP 1-113-.
–
Attach valve spring assembly lever -MP 1-114- and in-
sert -MP 1-114/1- together with threaded connector
-1- onto the cylinder head.
–
Press down assembly lever -2-.
–
Take out collets.
Note
Release collets that are tight by striking light blows with a
hammer on the assembly lever.
–
Pull out valves.
15-2 2
page
FABIA 2000 1.0/37; 1.4/44; 1.4/50 Engine, Mechanical Components
Exhaust valve
0.6 mm
Repairing cylinder head
2
1
MP 1-114/1
MP 1-113
S15-0008
MP 1-114
MP 1-113
S15-0124
Edition 09.03
S00.5305.04.20