Maximum Toner Density Adjustment To Paper Type - Toshiba e-STUDIO2330C Service Handbook

3.2.12

Maximum toner density adjustment to paper type

The maximum toner amount adhering to the paper can be controlled.
Code
1612
1613
1614
1615
1616
1617
1618
1619
1620
Note:
The larger the value is, the more frequently fusing offsetting occurs.
<Procedure>
The procedure is the same as that of
3.2.13 Maximum text density adjustment
The maximum text density of each color at Full Color Mode can be adjusted as follows.
Color Code
Yellow 1630
Magenta 1631
Cyan 1632
Black 1633
Make a test copy and compare the image obtained with the current settings; if necessary, make
adjustments according to the following procedure.
Note:
Be sure that this adjustment is made after performing
adjustment".
<Procedure>
The procedure is the same as that of
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
ADJUSTMENT
Paper type
Plain paper
Thick paper 1
Thick paper 2
Thick paper 3
OHP film
Special paper 1
Special paper 2
Recycled paper
Thick paper 4
P.3-31 "3.2.2 Density adjustment".
Item to be adjusted
Maximum text density
P.3-31 "3.2.2 Density adjustment".
Remarks
The smaller the value is, the toner amount adhered
decreases of the high density area (ex. prevention of fusing
offsetting, etc.).
Acceptable values: 0 to 255
(Default: Plain paper: 255, Thick paper 1: 255,
Thick paper 2: 255, Thick paper 3: 255, OHP film: 240,
special paper 1: 255, special paper 2: 255,
Recycled paper: 255, Thick paper 4: 255)
Remarks
The larger the value is, the darker the maximum text density
of each color to be adjusted becomes.
Acceptable values: 0 to 10 (Default: 5)
P.3-29 "3.2.1 Automatic gamma
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
3 - 40
<Adjustment Mode (05)>
<Adjustment Mode (05)>