Ready; Drawer Feed Copying - Toshiba e-STUDIO 5540C Service Manual

[ 2 ] Ready (ready for copying)
 Buttons on the control panel enabled
 When no button is pressed for a certain period of time,
- The set number "1" and reproduction ratio "100%" are displayed. The equipment returns to
the normal ready state.
 The fuser unit repeats rotation and stopping
[ 3 ] Drawer feed copying (1st drawer paper feeding)
1. Press the [START] button.
"READY" changes to "COPYING".
The exposure lamp (EXP) is turned ON
The scan motor (M1) is turned ON.  Carriages-1 and -2 move forward.
The polygonal motor (M34) rotates at high speed.
The drum motor (M27, M28), transport motor (M40, M41), transfer belt motor (M13), 2nd transfer
cam motor (M48), developer unit motor (M29, M31), developer unit mixer motor (M30, M32),
fuser motor (M6) and exit motor (M2) are turned ON.
- The drum, transfer belt, fuser unit, developer unit and exit roller are driven.
2. Drawer paper feeding
The fans are rotated at high speed and feed motor (M42) is turned ON.
- The pickup roller, feed roller, separation roller and transport roller start to rotate.
Paper reaches the 1st drawer feed sensor (S78).
- The 1st drawer feed sensor (S78) is turned ON.
Paper reaches the registration roller
- The registration sensor (S52) is turned ON and aligning is performed.
The feed motor (M42) is turned OFF after a certain period of time.
3. After a certain period of time passed from the carriage operation
The registration motor (M39) is turned ON after a certain period of time.  Paper is transported to
the transfer area.
The copy counter operates.
4. Completion of scanning
The exposure lamp (EXP) is turned OFF.
The Scan motor (M1) is turned OFF.
The Registration motor (M39) is turned OFF (after the trailing edge of the paper passed the
registration roller).
"READY (PRINTING)" is displayed.
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
OUTLINE OF THE MACHINE
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
3 - 48