Cfm Port Settings - D-Link DGS-3630 Series Reference Manual

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
Parameter
MAC Address
Period
PDU Priority
Click the Apply button to accept the changes made.
The fields that can be configured in Clear CFM LM are described below:
Parameter
Type
Click the Clear button to clear the CFM LM statistics information based on the selection made.
Click the Clear All button to clear all the CFM LM statistics information.
Click the Back button to return to the previous window.

CFM Port Settings

This window is used to display and configure the CFM port settings.
To view the following window, click OAM > CFM > CFM Port Settings, as shown below:
The fields that can be configured are described below:
Parameter
Unit
From Port - To Port
State
Click the Apply button to accept the changes made.
Click the Show Detail button to more detailed information about the CFM settings on the specified port.
Description
Enter the MAC address for the LM test here.
Select the time period here. This specifies the transmitting interval of the LM PDU.
Options to choose from are 100ms, 1sec, and 10sec.
Select the PDU priority value here. The range is from 0 to 7. This specifies the
802.1p priority to be set in the LMM messages transmitted by the MEP. The
default value is the PDU priority of the MEP.
Description
Select the type of information to clear here. Options to choose from are:
• Result - Specifies to clear the stored LM results.
• Statistics - Specifies to clear the stored statistics of ETH-LM frames (LMM
and LMR).
Figure 10-12 CFM Port Settings Window
Description
Select the Switch unit ID that will be used here.
Select the Switch port range that will be used here.
Select the enable or disable the CFM feature on the specified port(s) here.
540