D-Link DGS-3630 Series Reference Manual page 389

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
Parameter
Interface VLAN
IPv4
IPv6
Area Tag
Click the Apply button to accept the changes made.
Click the Find button to locate a specific entry based on the information entered.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove the specific entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
After clicking the Edit button, the following page will appear.
The fields that can be configured are described below:
Parameter
Circuit Type
Hello Padding
Description
Enter the VLAN ID that will be used here. The range is from 1 to 4094.
Select this option to enable the ISIS routing protocol for IPv4 on the interface.
Select this option to enable the ISIS routing protocol for IPv6 on the interface.
Enter the ISIS area tag here. This can be up to 16 characters long.
Figure 6-225 ISIS Interface Settings (Edit) Window
Description
Select the circuit type here. Options to choose from are:
• Level-1 - Specifies to configure the Switch for Level 1 adjacency only.
• Level-1-2 - Specifies to configure the Switch for Level 1 and Level 2
adjacency.
• Level-2 - Specifies to configure the Switch for Level 2 adjacency only.
Select to enable or disable the hello padding feature here. ISIS hello packets are
padded to the full maximum transmission unit (MTU) size. Padding ISIS hello
packets to the full MTU allows early detection of errors that resulted from
transmission problems with large frames or errors that resulted from mismatched
MTUs on adjacent interfaces.
Disable the hello padding in order to avoid wasting network bandwidth in case the
MTU of both interfaces are the same.
377