Queue Settings; Cos To Queue Mapping - D-Link DGS-3630 Series Reference Manual

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide

Queue Settings

This window is used to display and configure the queue settings.
To view the following window, click QoS > Basic Settings > Queue Settings, as shown below:
The fields that can be configured are described below:
Parameter
Unit
From Port - To Port
Queue ID
WRR Weight
WDRR Quantum
Click the Apply button to accept the changes made.

CoS to Queue Mapping

This window is used to display and configure the CoS-to-Queue mapping settings.
To view the following window, click QoS > Basic Settings > CoS to Queue Mapping, as shown below:
Figure 7-3 Queue Settings Window
Description
Select the Switch unit that will be used for this configuration here.
Select the range of ports that will be used for this configuration here.
Enter the queue ID value here. This value must be between 0 and 7.
Enter the WRR weight value here. This value must be between 0 and 127. To
satisfy the behavior requirements of Expedited Forwarding (EF), the highest
queue is always selected by the Per-hop Behavior (PHB) EF and the schedule
mode of this queue should be strict priority scheduling. So the weight of the last
queue should be zero while the Differentiate Service is supported.
Enter the WDRR quantum value here. This value must be between 0 and 127.
397