Reset - D-Link DGS-3630 Series Reference Manual
Layer 3 stackable managed switch web ui reference guide
Hide thumbs
Also See for DGS-3630 Series:
- Reference manual (184 pages) ,
- Hardware installation manual (71 pages) ,
- User manual (9 pages)
Table of Contents
Advertisement
DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
Parameter
Click the Start button to initiate the route trace for each individual section.
The fields that can be configured in IPv6 Trace Route are described below:
Parameter
IPv6 Address
Domain Name
Initial TTL
Max TTL
Port
Timeout
Length
Frequency
Source IPv6 Address
Probe Number
Click the Start button to initiate the route trace for each individual section.
After clicking the Start button in IPv4 Trace Route section, the following IPv4 Trace Route Result section will appear:
Click the Back button to stop the trace route and return to the IPv4 Trace Route section.
Reset
This window is used to reset the Switch's configuration to the factory default settings.
To view the following window, click Tools > Reset, as shown below:
Description
default value is 1.
Description
Select and enter the IPv6 address of the destination here.
Select and enter the domain name of the destination here.
Enter the initial Time-To-Live (TTL) value here. The range is from 1 to 255.
Enter the Time-To-Live (TTL) value of the trace route request here. This is the
maximum number of routers that a trace route packet can pass. The trace route
option will cross while seeking the network path between two devices. The range
for the TTL is 1 to 255 hops.
Enter the port number here. The value range is from 1 to 65535.
Enter the timeout period while waiting for a response from the remote device
here. A value of 1 to 65535 seconds can be specified. The default is 5 seconds.
Enter the length value here. This specifies the number of bytes of the outgoing
datagram. The range is from 1 to 1420 bytes.
Enter the frequency time for the trace route here. The range is from 0 to 86400.
Enter the source IPv6 address here. The specified IPv6 address must one of the
IPv6 addresses configured for the Switch.
Enter the probe time number here. The range is from 1 to 1000. If unspecified, the
default value is 1.
Figure 15-25 Trace Route (Start) Window
624
Advertisement
Table of Contents
