D-Link DGS-3630 Series Reference Manual page 285

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
Parameter
Instance ID
Area ID
Interface Name
Click the Apply button to accept the changes made.
The fields that can be configured in OSPF Interface Table are described below:
Parameter
Process ID
Interface Name
Click the Find button to locate a specific entry based on the information entered.
Click the Process ID link (1) to access and configure the specified OSPFv3 process.
Click the Delete button to delete the specified entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
After clicking the Process ID link (1) button, the following page will appear.
The fields that can be configured are described below:
Parameter
Cost
Hello Interval
Description
Enter the instance identifier here. The range is from 0 to 255. If not specified, the
default is 0.
Enter the identifier of the area here. It can be specified as an IPv4 address.
Enter the name of the VLAN interface here. This name can be up to 12 characters
long.
Description
Enter the ID for an IPv6 OSPF routing process here. The range is from 1 to
65535.
Enter the name of the interface here.
Figure 6-86 OSPFv3 Interface Settings (Process ID) Window
Description
Enter cost value here. It is an integer value expressed as the link-state metric.
The range is from 1 to 65535. Select the Default option to use the default value.
Enter the Hello Interval value, between the hello packets that the router sends on
an interface here. This value is advertised in the hello packets. The shorter the
273