D-Link DGS-3630 Series Reference Manual page 560

Layer 3 stackable managed switch web ui reference guide

Hide thumbs Also See for DGS-3630 Series:

Table of Contents

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide

The fields that can be configured in Ethernet OAM Configuration Settings are described below:

From Port - To Port

Critical Event

Link Monitor

Figure 10-23 Ethernet OAM Configuration Settings Window

Select the Switch unit ID that will be used here.

Select the Switch port range that will be used here.

Select to enable or disable the dying gasp feature here. This feature is used to

configure the capability of the dying gasp event. If the capability for the dying gasp

event is disabled, the port will never send out OAM PDUs with the dying gasp

event bit set when an unrecoverable local failure condition has occurred.

Select to enable or disable the critical event feature here. This feature is used to

configure the capability of the critical event. If the capability for a critical event is

disabled, the port will never send out OAM PDUs with critical event bit set when

an unspecified critical event has occurred.

Select the link monitor feature here. Options to choose from are Error Symbol,

Error Frame, Error Frame Seconds, and Error Frame Period.

• Error Symbol - This feature is used to enable notifying the Ethernet OAM

error symbol event and configure the monitor threshold and window on the

specified port.

• Error Frame - This feature is used to enable notifying the Ethernet OAM

error frame event and configure the monitor threshold and window on the

specified port.