Sflow Sampler Settings - D-Link DGS-3630 Series Reference Manual

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Receiver Index
Owner Name
Expire Time
Max Datagram Size
Collector Address
UDP Port
VRF Name
Click the Apply button to accept the changes made.
Click the Reset button to reset the specified entry's settings to the default settings.

sFlow Sampler Settings

This window is used to display and configure the sFlow sampler settings.
To view the following window, click Monitoring > sFlow > sFlow Sampler Settings, as shown below:
The fields that can be configured are described below:
Parameter
Unit
From Port - To Port
Instance
Receiver
Mode
Description
Enter the index number of the receiver here. This number must be between 1 and
4.
Enter the owner name of the receiver here. This name can be up to 32 characters
long.
Enter the expiration time for the entry here. The parameters of the entry will reset
when the timer expired. The range is from 0 to 2000000 seconds. Selecting
Infinite specifies that the entry will not expire.
Enter the maximum number of data bytes of a single sFlow datagram here. The
range is from 700 to 1400 bytes. By default, this value is 1400 bytes.
Enter the remote sFlow collector's IPv4 or IPv6 address here.
Enter the remote sFlow collector's UDP port number here. This number must be
between 1 and 65535. By default, this value is 6343.
Enter the name of the VRF instance here. This name can be up to 12 characters
long.
Figure 13-20 sFlow Sampler Settings Window
Description
Select the Switch unit that will be used for this configuration here.
Select the appropriate port range used for the configuration here.
Enter the instance index number if multiple samplers are associated with one
interface. The valid range is from 1 to 65535.
Enter the receiver index for this sampler. If not specified, the value is 0. This value
must be between 1 and 4.
Select the mode here. Options to choose from are Inbound and Outbound.
• Selecting Inbound specifies to sample ingress packets. This is the default
direction of a sampler.
599