Management; Command Logging; User Accounts Settings - D-Link DGS-3630 Series Reference Manual

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
4.

Management

Command Logging

User Accounts Settings

Password Encryption
Password Recovery
Login Method
SNMP
RMON
Telnet/Web
Session Timeout
DHCP
DHCP Auto Configuration
DHCP Auto Image Settings
DNS
NTP
IP Source Interface
File System
Stacking
Virtual Stacking (SIM)
D-Link Discovery Protocol
SMTP Settings
Reboot Schedule Settings
NLB FDB Settings
SD Card Management
Command Logging
This window is used to display and configure the command logging function. The command logging function is used to
log the commands that have successfully been configured on the Switch via the command line interface. The
command, along with information about the user that entered the command, is included in the system log. Commands
that do not cause a change in the Switch configuration or operation (such as 'show' commands) are not logged.
To view the following window, click Management > Command Logging, as shown below:
The fields that can be configured are described below:
Parameter
Command Logging State
Click the Apply button to accept the changes made.
User Accounts Settings
On this page, user accounts can be created and updated. Active user account sessions can also be viewed on this
page.
There are several configuration options available in the Web User Interface (Web UI). The set of configuration options
available to the user depends on the account's Privilege Level.
Figure 4-1 Command Logging Window
Description
Select to enable or disable the command logging function here.
33