Port Security Port Settings - D-Link DGS-3630 Series Reference Manual

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
Parameter Description
Trap State Select to enable or disable port security traps on the Switch.
Click the Apply button to accept the changes made.
The fields that can be configured in Port Security Trap Rate Settings are described below:
Parameter Description
Enter the number of traps per second. The range is from 0 to 1000. The default value 31 indicates an
Trap Rate
SNMP trap to be generated for every security violation.
Click the Apply button to accept the changes made.
The fields that can be configured in Port Security System Settings are described below:
Parameter Description
System Enter the maximum number of secure MAC addresses allowed. If not specified, the default
Maximum value is No Limit. The valid range is from 1 to 12288. Tick the No Limit checkbox to allow the
Address maximum number of secure MAC address.
Click the Apply button to accept the changes made.
The fields that can be configured in Port Security VLAN Settings are described below:
Parameter
VID List
VLAN Max Learning
Address
Click the Apply button to accept the changes made.
The fields that can be configured in Find VLAN are described below:
Parameter
VID
Click the Find button to locate a specific entry based on the information entered.

Port Security Port Settings

This window is used to display and configure the port security port settings.
To view the following window, click Security > Port Security > Port Security Port Settings, as shown below:
Description
Enter the VLAN ID(s) here.
Enter the maximum number of allowed MAC addresses that can be learned on
the specified VLAN(s) here. The range is from 1 to 12288. Tick the No Limit
checkbox to allow the maximum number of secure MAC address.
Description
Enter the VLAN ID that will be located here.
455