Ethernet Oam; Ethernet Oam Settings - D-Link DGS-3630 Series Reference Manual

Layer 3 stackable managed switch web ui reference guide

Hide thumbs Also See for DGS-3630 Series:

Table of Contents

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide

Ethernet OAM

This window is used to display and configure the Ethernet Operations, Administration, and Maintenance (OAM)

To view the following window, click OAM > Ethernet OAM > Ethernet OAM Settings, as shown below:

The fields that can be configured in Ethernet OAM Settings are described below:

From Port - To Port

Received Remote

Figure 10-22 Ethernet OAM Settings Window

Select the Switch unit ID that will be used here.

Select the Switch port range that will be used here.

Select to enable or disable the Ethernet OAM feature on the specified port(s)

here. After enabling this function on the interface, the interface will start OAM

discovery. If the OAM mode of this interface is active, it initiates the discovery.

Otherwise, it reacts to the discovery received from the peer.

Select the Ethernet OAM mode here. Options to choose from are Active and

Passive. The following two actions are allowed by ports in the active mode, but

disallowed by ports in the passive mode. (1) Initiate OAM discovery. (2) Start or

stop remote loopback.

Select to configure the behavior of the received remote loopback requirement

from the peer on the specified port(s) here. Options to choose from are Ignore

and Process.

• Ignore - Specifies not to react to remote loopback requirements from a peer.