D-Link DGS-3630 Series Reference Manual page 323

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
ACL Type
ACL List
Click the Find button to display a list of access lists based on the selection made.
Click the Show All button to display all configured access lists.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
Click the Apply button to use the selected access list.
PIM for IPv6 RP Candidate
This window is used to display and configure the IPv6 PIM RP candidate settings. Only one group access list can be
specified for each interface. The latest configuration overrides the previous one. This feature can be issued multiple
times for different interfaces. This configuration causes the router to send a PIMv2 message advertising itself as a
candidate RP to the BSR.
To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv6 > PIM for
IPv6 RP Candidate, as shown below:
The fields that can be configured are described below:
Figure 6-135 PIM for IPv6 RP Address (Show List) Window
Description
Select the ACL type that will be used to display the type of existing access lists in
the table here. Options to choose from are IP ACL, Expert IP ACL, IPv6 ACL,
Expert IPv6 ACL, MAC ACL, and Expert ACL.
Select the radio button of the access list in the table that will be used here.
Figure 6-136 PIM for IPv6 RP Candidate Window
311