D-Link DGS-3630 Series Reference Manual page 548

Layer 3 stackable managed switch web ui reference guide

Hide thumbs Also See for DGS-3630 Series:

Table of Contents

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide

Figure 10-7 CFM Settings (Add MA, Add MEP, MEPID Detail, Edit) Window

The fields that can be configured are described below:

PDU Priority

Select to enable or disable the MEP state on the interface here.

Select to enable or disable the CCM state here.

Select the PDU priority value here. The range is from 0 to 7. This feature is used

to define the 802.1p priority that is set in the CCM and other CFM PDUs

transmitted by the MEP.

Select the type of defects whose fault alarms can be sent by this MEP. Options to

choose from are None, All, MAC-Status, Remote-CCM, Error-CCM, and XCON-

• None - Specifies that no fault alarm will be sent.

• All - Specifies that the fault alarms can be sent for all types of defects.

• MAC-Status - Specifies that the fault alarms can be sent for the defects

whose priority is equal to or higher than DefMACstatus.

• Remote-CCM - Specifies that the fault alarms can be sent for the defects

whose priority is equal to or higher than DefRemoteCCM.

• Error-CCM - Specifies that the fault alarms can be sent for the defects

whose priority is equal to or higher than DefErrorCCM.

• XCON-CCM - Specifies that only the fault alarm of DefXconCCM can be