Mpls Ldp Neighbor Information - D-Link DGS-3630 Series Reference Manual

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Neighbor Targeted
Targeted Hello Interval
Targeted Hello Hold Time
Click the Apply button to accept the changes made.
Click the Delete button to remove the specific entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.

MPLS LDP Neighbor Information

This window is used to view and clear the MPLS LDP neighbor information.
To view the following window, click MPLS > MPLS LDP Neighbor Information, as shown below:
The fields that can be configured are described below:
Parameter
Peer
Click the Find button to locate a specific entry based on the information entered.
Click the Clear by Peer button to clear the information related to the peer entered.
Figure 11-5 MPLS LDP Neighbor Targeted Settings Window
Description
Enter the LSR ID of the targeted peer here. The targeted peer is used to establish
the LDP session with the non-directly connected neighbor.
Enter the interval to the hello message for sessions with extended peers here.
The range is from 5 to 65535 seconds. Select the Default option to use the
default value.
Enter the hold-time of the hello messages for sessions with extended peers here.
The range is from 15 to 65535 seconds. Select the Default option to use the
default value.
Figure 11-6 MPLS LDP Neighbor Information Window
Description
Enter the IP address which is used as the peer LSR ID here.
564