Cfm Port Settings - D-Link xStack Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
PDU Priority
Type
Click the Apply button to accept the changes made for each individual section.
Click the Clear button to clear the frame loss measurement information.
Click the <<Back button to discard the changes made and return to the previous page.

CFM Port Settings

This window is used to configure the CFM port state.
To view this window, click OAM > CFM > CFM Port Settings, as shown below:
The fields that can be configured are described below:
Parameter
10sec:1min - Specifies the transmission period of ten seconds and the diagnostic
interval is one minute.
Select the PDU priority option. This specifies the 802.1p priority which is set in the
DMM message transmitted by the MEP.
0 to 7 - Select the 802.1p priority which is set in the DMM message transmitted by the
MEP. This value must be between 1 and 7.
Select the type that will be cleared.
Results - Specifies to clear the stored frame delay measurement results. If none of
them is specified, both of them are cleared.
Statistics - Specifies to clear the stored the statistics of ETH-DM frames (DMM, DMR).
If none of them is specified, both of them are cleared.
Figure 11-12 CFM Port Settings window
Description
509