Ping Mpls - D-Link DGS-3630 Series Reference Manual

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
IP
Mask
VC
VC ID
Click the Apply button to accept the changes made.
Click the Delete button to remove an entry based on the information selected/entered.
Click the Delete All button to remove all the entries associated with this feature.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
Click the Back button to return to the previous window.

Ping MPLS

This window is used to check the connectivity of the LSP for the specified FEC. If there is no LSP for the specified
FEC, the "Destination unreachable" message will be displayed. Otherwise, MPLS echo request messages will be sent
out to along with the LSP of the specified FEC. If the egress LSR received the request message, it will reply the
request message sender with an MPLS echo reply message. If the sender cannot receive replies before the timeout,
the "Request timed out" message will be displayed.
To view the following window, click MPLS > Ping MPLS, as shown below:
Figure 11-22 MPLS QoS Settings (Edit, Binding FECs Settings) Window
Description
Enter the FEC IP address here. Use this feature to apply an MPLS QoS policy to
FECs. The QoS policy will be applied to all MPLS packets of the FEC. A FEC can
only be bound to at most one policy.
Enter the FEC subnet mask here.
Enter the FEC VC address here.
Enter the FEC VC ID here.
Figure 11-23 Ping MPLS Window
573