Lldp Port Settings - D-Link DGS-3630 Series Reference Manual

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
Parameter
Message TX Hold Multiplier
ReInit Delay
TX Delay
Click the Apply button to accept the changes made.

LLDP Port Settings

This window is used to display and configure the LLDP port settings.
To view the following window, click L2 Features > LLDP > LLDP Port Settings, as shown below:
The fields that can be configured are described below:
Parameter
Unit
From Port - To Port
Notification
Subtype
Admin State
IP Subtype
Description
each physical interface. The range is from 5 to 32768 seconds.
Enter the multiplier on the LLDPDUs transmission interval that used to calculate
the TTL value of an LLDPDU. This value must be between 2 and 10.
Enter the delay value for LLDP initialization on an interface. This value must be
between 1 and 10 seconds.
Enter the delay value for sending successive LLDPDUs on an interface. The valid
values are from 1 to 8192 seconds and should not be greater than one-fourth of
the transmission interval timer.
Figure 5-96 LLDP Port Settings Window
Description
Select the Switch unit that will be used for this configuration here.
Select the appropriate port range used for the configuration here.
Select to enable or disable the notification feature here.
Select the subtype of LLDP TLV(s). Options to choose from are MAC Address,
and Local.
Select the local LLDP agent and allow it to send and receive LLDP frames on the
port. Options to choose from are TX, RX, TX and RX, and Disabled.
• TX - The local LLDP agent can only transmit LLDP frames.
• RX - The local LLDP agent can only receive LLDP frames.
• TX and RX - The local LLDP agent can both transmit and receive LLDP
frames.
• Disabled - The local LLDP agent can neither transmit nor receive LLDP
frames.
The default value is TX and RX.
Select the type of the IP address information to be sent. Options to choose from
205