D-Link DGS-3630 Series Reference Manual page 21

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Unit
From Port - To Port
Medium Selecting
Medium Type
State
MDIX
Auto Downgrade
Flow Control
Duplex
Speed
Figure 3-4 Port Settings Window
Description
Select the stacking unit ID of the Switch that will be configured here.
Select the appropriate port range used for the configuration here.
Select the port medium type here. Options to choose from are Auto, RJ45 and
SFP.
Note: Selecting the SFP option, includes the use of SFP+ transceivers for 10G
connectivity.
Select the port medium type here. Options to choose from are RJ45 and SFP.
Note: Selecting the SFP option, includes the use of SFP+ transceivers for 10G
connectivity.
Select this option to enable or disabled the physical port here.
Select the Medium Dependent Interface Crossover (MDIX) option here. Options to
choose from are Auto, Normal, and Cross.
• Auto - Select this option for auto-sensing of the optimal type of cabling.
• Normal - Select this option for normal cabling. If this option is selected, the
port is in the MDIX mode and can be connected to a PC NIC using a straight-
through cable or a port (in the MDI mode) on another Switch through a cross-
over cable.
• Cross - Select this option for cross-over cabling. If this option is selected, the
port is in the MDI mode and can be connected to a port (in the MDIX mode)
on another Switch through a straight cable.
Select to enable or disable the feature to automatically downgrade the advertised
speed in the event that a link cannot be established at the available speed.
Select to either turn flow control On or Off here. Ports configured for full-duplex
use 802.3x flow control and Auto ports use an automatic selection of the two.
Note: This feature will not work through Switches that are physically stacked.
Select the duplex mode used here. Options to choose from are Auto and Full.
Select the port speed option here. This option will manually force the connection
speed on the selected port to only connect at the speed specified here.
Options to choose from are Auto, 10M, 100M, 1000M, 1000M Master, 1000M
9