D-Link DGS-3630 Series Reference Manual page 509

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
IPv6 Source Guard
IPv6 Source Guard Settings
This window is used to display and configure the IPv6 source guard settings.
To view the following window, click Security > IMPB > IPv6 > IPv6 Source Guard > IPv6 Source Guard Settings,
as shown below:
The fields that can be configured are described below:
Parameter
Policy Name
Global Auto-Configure
Address
Link Local Traffic
Validate Address
Validate Prefix
Target Port
Unit
From Port - To Port
Click the Apply button to accept the changes made.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove the specified entry.
IPv6 Neighbor Binding
This window is used to display and configure the IPv6 neighbor binding settings.
To view the following window, click Security > IMPB > IPv6 > IPv6 Source Guard > IPv6 Neighbor Binding, as
shown below:
Figure 9-62 IPv6 Source Guard Settings Window
Description
Enter the policy name here. This name can be up to 32 characters long.
Select to permit of deny data traffic from the auto-configured global address. It is
useful when all global addresses on a link are assigned by DHCP and the
administrator that wants to block hosts with self-configured addresses from
sending traffic.
Select to permit of deny hardware permitted data traffic send by the link-local
address.
Select to enable or disable the validate address feature here. This is used to
enable the IPv6 source guard to perform the validate address feature.
Select to enable or disable the validate prefix feature here. This is used to enable
the IPv6 source guard to perform the IPv6 prefix-guard operation.
Tick this option to specify the target port.
Select the Switch unit that will be used for this configuration here.
Select the appropriate port range used for the configuration here.
497