D-Link DGS-3630 Series Reference Manual page 168

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Rule ID
Src-MAC Address
Dst-MAC Address
Priority
Inner VID
Ethernet Type
Src-IP Address
Dst-IP Address
DSCP
Source Port
Destination Port
IP Protocol
Action
New Outer VID
802.1P Priority
Figure 5-49 VLAN Mapping Profile (Ethernet-IP, Add Rule) Window
Description
Enter the VLAN mapping rule ID here. If not specified, the rule ID begins from 10
and is incremented by 10 for every new rule. The range is from 1 to 10000
Enter the source MAC address here.
Enter the destination MAC address here.
Select the 802.1p priority value here. The range is from 0 to 7. A lower value has
a higher priority.
Enter the inner VLAN ID here. The range is from 1 to 4094.
Enter the Ethernet type value here. The range is from 0x0 to 0xFFFF.
Enter the source IPv4 address and subnet mask here.
Enter the destination IPv4 address and subnet mask here.
Enter the DSCP value here. The range is from 0 to 63.
Enter the source TCP/UDP port number here. The range is from 1 to 65535.
Enter the destination TCP/UDP port number here. The range is from 1 to 65535.
Enter the Layer 3 IP protocol value here. The range is from 0 to 255.
Select the action that will be taken here. Options to choose from are Dot1q-
Tunnel and Translate.
• Dot1q-Tunnel - Specifies that the outer-VID will be added for matched
packets.
• Translate - Specifies that the outer-VID will replace the outer-VID of the
matched packets.
Enter the new outer VLAN ID here. The range is from 1 to 4094.
Select the 802.1p priority value here. The range is from 0 to 7. A lower value has
a higher priority.
156