Mac Address Table Settings - D-Link DGS-3630 Series Reference Manual

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
Multicast Static FDB
This window is used to display and configure the multicast static FDB settings.
To view the following window, click L2 Features > FDB > Static FDB > Multicast Static FDB, as shown below:
The fields that can be configured are described below:
Parameter
Unit
From Port - To Port
VID
MAC Address
Click the Apply button to accept the changes made.
Click the Delete All button to remove all the entries.
Click the Delete button to remove the specific entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.

MAC Address Table Settings

This window is used to display and configure the global MAC address table settings.
To view the following window, click L2 Features > FDB > MAC Address Table Settings, as shown below:
The fields that can be configured are described below:
Parameter
Aging Time
Figure 5-2 Multicast Static FDB Window
Description
Select the stacking unit ID of the Switch that will be configured here.
Select the range of ports that will be used for this configuration here.
Enter the VLAN ID of the VLAN the corresponding MAC address belongs to.
Enter the static destination MAC address of the multicast packets. This must be a
multicast MAC address. The format of the destination MAC address is 01-XX-XX-
XX-XX-XX.
Figure 5-3 MAC Address Table Settings (Global Settings) Window
Description
Enter the MAC address table aging time here. This value must be between 10
and 1000000 seconds. Entering 0 will disable MAC address aging. By default, this
121