D-Link DGS-3630 Series Reference Manual page 422

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
Click the Set Action button to configure the set action settings for the specified entry.
Click the Policer button to configure the policer settings for the specified entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
After clicking the Set Action button, the following page will appear.
The fields that can be configured are described below:
Parameter
None
Specify
New Precedence
New DSCP
New CoS
New Cos Queue
Click the Back button to return to the previous window.
Click the Apply button to accept the changes made.
After clicking the Policer button, the following page will appear.
Figure 7-17 Policy Map (Set Action) Window
Description
Select this option to specify that no action will be taken.
Select this option to specify that action will be taken based on the configurations
made.
Select the new precedence value for the packet here. The range is from 0 to 7.
Select the IPv4 only option to specify that IPv4 precedence will be marked only. If
not selected, then both IPv4 and IPv6 precedence will be marked. For IPv6
packets, the precedence is the most three significant bits of the traffic class of the
IPv6 header. Setting the precedence will not affect the CoS queue selection.
Select the new DSCP value for the packet here. The range is from 0 to 63. Select
the IPv4 only option to specify that the IPv4 DSCP will be marked only. If not
selected, then both the IPv4 and IPv6 DSCP will be marked. Setting the DSCP
will not affect the CoS queue selection.
Select the new CoS value to the packet here. The range is from 0 to 7. Setting the
CoS will not affect the CoS queue selection.
Select the new CoS queue value to the packets here. This will overwrite the
original CoS queue selection. Setting the CoS queue will not take effect if the
policy map is applied for the egress flow on the interface.
410