Ecmp Settings - D-Link DGS-3630 Series Reference Manual

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
Parameter
VRF Name
Distance Default
Distance Static
Click the Apply button to accept the changes made.
After clicking the Please Select button, the following page will appear.
Select the VRF entry and click the OK button to use the selected VRF entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.

ECMP Settings

This window is used to display and configure the Equal-Cost Multi-Path (ECMP) routing settings. This is used to
configure the load balancing hash algorithm and used to determine the next hop entry for multiple paths destined for
the same destination.
To view the following window, click L3 Features > ECMP Settings, as shown below:
The fields that can be configured in ECMP Load Balancing Settings are described below:
Parameter
Destination IP
Source IP
CRC 32 Lower
Description
Enter the name of the VRF instance here. This name can be up to 12 characters
long. Click the Please Select button to select a pre-configured VRF instance that
will be used here.
Enter the administrative distance of default routes here. The range is from 1 to
255. By default, this value is 1.
Enter the administrative distance of static default routes here. The range is from 1
to 255. By default, this value is 60.
Figure 6-28 Route Preference (Please Select) Window
Figure 6-29 ECMP Settings Window
Description
Select this option to use the destination IP address as the ECMP hash key.
Select this option to use the least significant bits of the source IP address as the
ECMP hashing algorithm.
Select this option to use the lower bits of CRC-32 as the ECMP hashing
algorithm.
233