D-Link DGS-3630 Series Reference Manual page 326

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Group Address/Prefix
Length
Source
Click the Find button to locate a specific entry based on the information entered.
Click the Show All button to display all the entries.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
PIM for IPv6 Register Settings
This window is used to display and configure the IPv6 PIM register settings.
To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv6 > PIM for
IPv6 Register Settings, as shown below:
The fields that can be configured in Register Checksum Wholepkt are described below:
Parameter
Register Checksum
Wholepkt
Figure 6-140 PIM for IPv6 RP Table Window
Description
Enter the multicast group IPv6 address and prefix length here.
Select the source to display here. Options to choose from are Bootstrap,
Embedded RP, and Static.
• Bootstrap - Specifies to display ranges learned through the BSR.
• Embedded RP - Specifies to display group ranges learned through the
embedded rendezvous point (RP).
• Static - Specifies to display ranges enabled by static configuration.
Figure 6-141 PIM for IPv6 Register Settings Window
Description
Select the enable or disable the register checksum whole-packet feature here.
When enabled, it configures the router to calculate the checksum of register
message over the entire PIM message including the data portion. By default, the
314