D-Link DGS-3630 Series Reference Manual page 235

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
Parameter
Click the Apply button to accept the changes made.
The fields that can be configured for ND Settings are described below:
Parameter
Hop Limit
Reachable Time
Managed Config Flag
Other Config Flag
RA Min Interval
RA Max Interval
RA Lifetime
RA Suppress
Click the Apply button to accept the changes made.
After selecting the Interface IPv6 Address tab option, at the top of the page, the following page will be available.
Click the Delete button to delete the specified entry.
After selecting the Neighbor Discover tab option, at the top of the page, the following page will be available.
Description
3600000 milliseconds, in multiples of 1000. If the specified time is 0, the router will
use 1 second on the interface and advertise 0 (unspecified) in the Router
Advertisement (RA) message.
Description
Enter the hop limit value here. The range is from 0 to 255. The IPv6 packet
originated by the system will also use this value as the initial hop limit.
Enter the Reachable Time here. The range is from 0 to 3600000 milliseconds. If
the specified time is 0, the router will use 1200 seconds on the interface and
advertise 1200 (unspecified) in the RA message. The Reachable Time is used by
the IPv6 node in determining the reachability of the neighbor nodes.
Turn the Managed Config Flag option On or Off here. When the neighbor host
receives the RA which has flag turned on, the host should use a stateful
configuration protocol to obtain IPv6 addresses.
Turn the Other Config Flag option On or Off here. By setting the other
configuration flag on, the router instructs the connected hosts to use a stateful
configuration protocol to obtain auto-configuration information other than the IPv6
address.
Enter the minimum RA interval time value here. The range is from 3 to 1350
seconds. This value must be smaller than 0.75 times the maximum value.
Enter the maximum RA interval time value here. The range is from 4 to 1800
seconds.
Enter the RA lifetime value here. The range is from 0 to 9000 seconds. The
lifetime value in RA instructs the received host the lifetime value for taking the
router as the default router.
Select to enable or disable the RA suppress feature here.
Figure 6-13 IPv6 Interface (Detail, Interface IPv6 Address) Window
Figure 6-14 IPv6 Interface (Detail, Neighbor Discover) Window
223