Traceroute Mpls Ipv4 - D-Link DGS-3630 Series Reference Manual

Layer 3 stackable managed switch web ui reference guide

Hide thumbs Also See for DGS-3630 Series:

Table of Contents

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide

The fields that can be configured are described below:

IPv4 Address

Click the Start button to initiate the MPLS ping.

After clicking the Start button, the following page will appear.

Click the Stop button to stop the MPLS ping.

Click the Back button to return to the previous window.

Traceroute MPLS IPv4

This window is used for hop-by-hop fault localization as well as path tracing the LSP of the specified FEC. If there is

no LSP for the specified FEC, the "Destination unreachable" message will be displayed. Otherwise, MPLS echo

request messages will be sent out to along the LSP of the specified FEC. The TTL in the outmost label of the MPLS

echo requests is set successively to 1, 2, 3, and so on. It forces the echo request expired at each successive LSR

along the LSP. The LSR returns an MPLS echo reply. If the sender cannot receive a reply before the timeout, the

trace route will stop.

To view the following window, click MPLS > Traceroute MPLS IPv4, as shown below:

Select and enter the FEC IPv4 address here whose LSP connectivity will be

Select and enter the FEC subnet mask here.

Select and enter the FEC VC IP address here.

Select and enter the FEC VC ID here.

Enter the ping time amount here. This is the amount of ping packets that will be

sent out. The range is from 1 and 255.

Enter the ping timeout value here. The range is from 1 to 99 seconds.

Figure 11-24 Ping MPLS (Start) Window

Figure 11-25 Traceroute MPLS IPv4 Window