D-Link DGS-3630 Series Reference Manual page 376

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
Neighbor Maximum Prefix Settings
This window is used to display and configure the BGP neighbor maximum prefix settings. This is used to control the
maximum number of prefixes that can be accepted from a BGP neighbor.
To view the following window, click L3 Features > BGP > BGP Neighbor > Neighbor Maximum Prefix Settings, as
shown below:
The fields that can be configured are described below:
Parameter
Address Family
Neighbor
Prefix Action
Prefix Max Count
Prefix Warning Threshold
Prefix Warning Only
Figure 6-209 Neighbor Maximum Prefix Settings Window
Description
Select the address family that will be used here. Options to choose from are:
• IPv4 Unicast - Specifies to configure the BGP neighbor maximum prefix
settings related to the IPv4 unicast address family.
• IPv4 VRF - Specifies to configure the BGP neighbor maximum prefix settings
related to the VRF instance in the IPv4 address family. Enter the name of the
VRF instance here. This name can be up to 12 characters long. Alternatively,
click the Please Select button to select a pre-configured VRF instance that
will be used here.
• IPv4 Multicast - Specifies to configure the BGP neighbor maximum prefix
settings related to the IPv4 multicast address family.
• L2VPN VPLS - Specifies to configure the BGP neighbor maximum prefix
settings related to the Layer 2 VPN VPLS address family.
• VPNv4 - Specifies to configure the BGP neighbor maximum prefix settings
related to the VPNv4 address family.
• IPv6 Unicast - Specifies to configure the BGP neighbor maximum prefix
settings related to the IPv6 unicast address family.
Select and enter the BGP neighbor here. Options to choose from are:
• IPv4 Address - Enter the IPv4 address of the BGP neighbor here.
• Peer Group - Enter the name of the peer group of the BGP neighbor here.
This name can be up to 16 characters long.
• IPv6 Address - Enter the IPv6 address of the BGP neighbor here.
Select to enable or disable the prefix action here.
Enter the maximum prefix count here. This specifies the maximum number of
prefixes acceptable from the specified neighbor.
Enter the prefix warning threshold value here. This specifies the percentage of the
maximum prefix limit to generate a warning message. The range is from 1 to 100
percent.
Select to enable or disable the prefix warning only feature here. When enabled
this specifies to only generate a system log message when the threshold was
exceeded. When disabled, the peering session will be terminated when the
364