D-Link DGS-3630 Series Reference Manual page 146

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
Parameter
Acceptable Frame
Ingress Checking
VLAN Precedence
Native VLAN
VID
Action
Add Mode
Allowed VLAN Range
Clone
From Port - To Port
Click the Apply button to accept the changes made.
Click the Back button to discard the changes made and return to the previous page.
When Trunk was selected as the VLAN Mode, the following page will appear.
The fields that can be configured are described below:
Parameter
VLAN Mode
Acceptable Frame
Ingress Checking
Native VLAN
Description
Secondary.
Select the acceptable frame behavior option here. Options to choose from are
Tagged Only, Untagged Only, and Admit All.
Select to enable or disable the ingress checking function.
Select the VLAN precedence option here. Options to choose from are Mac-based
VLAN and Subnet-based VLAN.
Tick this option to enable the native VLAN function.
After ticking the Native VLAN option the following parameter will be available.
Enter the VLAN ID used for this configuration here. This value must be between 1
and 4094.
Select the action that will be taken here. Options to choose from are Add,
Remove, Tagged, and Untagged.
Select whether to add an Untagged or Tagged parameters.
Enter the allowed VLAN range here.
Select this option to enable the clone feature.
Select the range of ports that will be used in the clone feature here.
Figure 5-23 VLAN Interface (Trunk) Window
Description
Select the VLAN mode option here. Options to choose from are Access, Hybrid,
Trunk, 802.1Q-Tunnel, Promiscuous, Host, Trunk Promiscuous, and Trunk
Secondary.
Select the acceptable frame behavior option here. Options to choose from are
Tagged Only, Untagged Only, and Admit All.
After selecting Trunk as the VLAN Mode the following parameter will be
available. Select to enable or disable the ingress checking function.
Tick this option to enable the native VLAN function. Also select if this VLAN
supports Untagged or Tagged frames.
134