D-Link DGS-3630 Series Reference Manual page 167

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Rule ID
Src-IPv6 Address
Dst-IPv6 Address
Action
New Outer VID
802.1P Priority
New Inner VID
Click the Back button to return to the previous window.
Click the Apply button to accept the changes made.
After clicking the Add Rule button next to an Ethernet-IP type profile, the following page will appear.
Figure 5-48 VLAN Mapping Profile (IPv6, Add Rule) Window
Description
Enter the VLAN mapping rule ID here. If not specified, the rule ID begins from 10
and is incremented by 10 for every new rule. The range is from 1 to 10000
Enter the source IPv6 address and prefix length here.
Enter the destination IPv6 address and prefix length here.
Select the action that will be taken here. Options to choose from are Dot1q-
Tunnel and Translate.
• Dot1q-Tunnel - Specifies that the outer-VID will be added for matched
packets.
• Translate - Specifies that the outer-VID will replace the outer-VID of the
matched packets.
Enter the new outer VLAN ID here. The range is from 1 to 4094.
Select the 802.1p priority value here. The range is from 0 to 7. A lower value has
a higher priority.
After selecting Dot1q-Tunnel as the action, enter the new inner VLAN ID here.
The range is from 1 to 4094. This option is only available when Dot1q-Tunnel
was selected as the action.
155