Mstp Port Information; Erps (G.8032); Erps - D-Link DGS-3630 Series Reference Manual

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
Click the Edit button to re-configure the specific entry.
Click the Apply button to accept the changes made.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.

MSTP Port Information

This window is used to display and configure the MSTP port information settings.
To view the following window, click L2 Features > STP > MSTP Port Information, as shown below:
The fields that can be configured are described below:
Parameter
Unit
Port
Cost
Priority
Click the Clear Detected Protocol button to clear the detected protocol settings for the port selected.
Click the Find button to locate a specific entry based on the information entered.
Click the Edit button to re-configure the specific entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.

ERPS (G.8032)

Ethernet Ring Protection Switching (ERPS) (ITU-T G.8032) integrates mature Ethernet Operations, Administration,
and Maintenance (OAM) functions and a simple Automatic Protection Switching (APS) protocol to provide sub-50ms
protection for Ethernet traffic in a ring topology. It ensures that there are no loops formed at the Ethernet layer.
One link within a ring will be blocked to avoid a Loop (RPL, Ring Protection Link). When the failure happens,
protection switching blocks the failed link and unblocks the RPL. When the failure clears, protection switching blocks
the RPL again and unblocks the link on which the failure is cleared.

ERPS

This window is used to display and configure the Ethernet Ring Protection Switching (ERPS) settings. STP and
Loopback Detection (LBD) should be disabled on the ring ports before enabling ERPS. The ERPS cannot be enabled
before the R-APS VLAN ring ports, RPL port, and RPL owner are configured.
Figure 5-54 MSTP Port Information Window
Description
Select the Switch unit that will be used for this display here.
Select the port number that will be cleared here.
After clicking the Edit button, enter the cost value here. This value must be
between 1 and 200000000.
After clicking the Edit button, select the priority value here. Options to choose
from are 0 to 240. By default this option is 0. A lower value has higher priority.
164