D-Link DGS-3630 Series Reference Manual page 234

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
IPv6 MTU
IPv6 State
Click the Back button to discard the changes made and return to the previous page.
Click the Apply button to accept the changes made.
The fields that can be configured for IPv6 Address Autoconfig are described below:
Parameter
State
Click the Apply button to accept the changes made.
The fields that can be configured for Static IPv6 Address Settings are described below:
Parameter
IPv6 Address
Click the Apply button to accept the changes made.
The fields that can be configured for NS Interval Settings are described below:
Parameter
NS Interval
Figure 6-12 IPv6 Interface (Detail, IPv6 Interface Settings) Window
Description
Enter the IPv6 MTU value here. The range is from 1280 to 65534 bytes. By
default, this value is 1500 bytes. This parameter is used to configure the MTU to
be advertised in RA messages.
Select to enable or disable the IPv6 interface global state here.
Description
Select to enable or disable the automatic configuration of the IPv6 address using
stateless auto-configuration here. Select the Default option to specify that if the
default router is selected on this interface, a default route will be installed using
that default router. This option can only be specified on one interface.
Description
Enter the IPv6 address for this IPv6 interface here. Select the EUI-64 option to
configure an IPv6 address on the interface using the EUI-64 interface ID. Select
the Link Local option to configure a link-local address for the IPv6 interface.
Description
Enter the Neighbor Solicitation (NS) interval value here. The range is from 0 to
222