Cfm Linktrace Settings - D-Link DGS-3630 Series Reference Manual

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
Parameter
PDU Priority
Click the Apply button to accept the changes made.

CFM Linktrace Settings

This window is used to display and configure the CFM link-trace settings.
To view the following window, click OAM > CFM > CFM Linktrace Settings, as shown below:
The fields that can be configured in CFM Linktrace Settings are described below:
Parameter
MAC Address
MEPID
MA Name
Domain Name
TTL
PDU Priority
Click the Apply button to accept the changes made.
The fields that can be configured in Find and Clear CFM Linktrace are described below:
Parameter
MEPID
MA Name
Domain Name
Click the Find button to locate a specific entry based on the information entered.
Click the Clear button to clear the entries based on the information specified.
Description
Select the 802.1p priority to be set in the transmitted LBMs here. If not specified, it
uses the same priority as the CCMs sent by the MA. The range is from 0 to 7.
Select the None option to use the default setting.
Figure 10-15 CFM Linktrace Settings Window
Description
Enter the destination MAC address here.
Enter the MEP ID here used to initiate the link-trace feature. The range is from 1
to 8191.
Enter the MA name here. The name can be up to 22 characters long.
Enter the MD name here. The name can be up to 22 characters long.
Enter the link-trace message's TTL value here. The range is from 2 to 255. The
default value is 64.
Select the 802.1p priority to be set in the transmitted LBMs here. If not specified, it
uses the same priority as the CCMs sent by the MA. The range is from 0 to 7.
Select the None option to use the default setting.
Description
Enter the MEP ID here. The range is from 1 to 8191.
Enter the MA name here. The name can be up to 22 characters long.
Enter the MD name here. The name can be up to 22 characters long.
542