D-Link DGS-3630 Series Reference Manual page 303

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
Parameter
Global State
Click the Apply button to accept the changes made.
The fields that can be configured in MLD Proxy Upstream Settings are described below:
Parameter
Interface VLAN
Upstream
Click the Apply button to accept the changes made.
The fields that can be configured in MLD Proxy Downstream Settings are described below:
Parameter
Interface VLAN
Downstream
Click the Apply button to accept the changes made.
The fields that can be configured in MLD Proxy Designated Forwarding Settings are described below:
Parameter
Interface VLAN
Designated Forwarding
Click the Apply button to accept the changes made.
MLD Proxy Group Table
This window is used to find and display MLD proxy group information.
To view the following window, click L3 Features > IP Multicast Routing Protocol > MLD Proxy > MLD Proxy
Group Table, as shown below:
The fields that can be configured are described below:
Description
Select to globally enable or disable the MLD proxy feature here.
Description
Enter the VLAN interface ID here. The range is from 1 to 4094.
Select to enable or disable the interface as the upstream MLD proxy here. This
feature only takes effect if the interface has an IPv6 address configured. Only one
upstream interface can exist on a MLD proxy device.
Description
Enter the VLAN interface ID here. The range is from 1 to 4094.
Select to enable or disable the interface as the downstream MLD proxy here. This
feature only takes effect when the interface has an IPv6 address configured.
Multiple downstream interfaces can be configured on an MLD proxy device.
Description
Enter the VLAN interface ID here. The range is from 1 to 4094.
Select to enable or disable designated forwarding on a non-querier MLD proxy
downstream interface here. To avoid local loops and redundant traffic for links
that are considered downstream links by multiple MLD-based forwarders, MLD
proxies use the MLD querier election to elect a single forwarder on a LAN.
Administrators can use this command to make a non-querier device a forwarder.
This feature does not take effect if the interface is not set as the downstream
interface or set as upstream interface.
Figure 6-110 MLD Proxy Group Table Window
291