D-Link DGS-3630 Series Reference Manual page 194

Layer 3 stackable managed switch web ui reference guide

Hide thumbs Also See for DGS-3630 Series:

Table of Contents

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide

IGMP Snooping Filter Settings

This window is used to display and configure the IGMP snooping filter settings.

To view the following window, click L2 Features > L2 Multicast Control > IGMP Snooping > IGMP Snooping Filter

Settings, as shown below:

The fields that can be configured in IGMP Snooping Rate Limit Settings are described below:

From Port - To Port

Limit Number

Click the Apply button to accept the changes made.

The fields that can be configured in IGMP Snooping Limit Settings are described below:

Figure 5-74 IGMP Snooping Filter Settings Window

Select the Switch unit ID that will be used here.

Select the Switch port range that will be used here. This is only available if the

Port option was selected as the action below.

Enter the limit number here. This is to configure the rate of IGMP control packets

that the Switch can process on a specific interface. The range is from 1 to 1000

packets per second. Select the No Limit option to remove the limitation.

Select the action that will be taken here. Options to choose from are Port and

Enter the VLAN ID here. This is the Layer 2 VLAN on a trunk port and applies the

filter to packets that arrive on that VLAN. The range is from 1 to 4094. This is only

available if the VLAN option was selected as the action.