D-Link DGS-3630 Series Reference Manual page 281

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
Parameter
Default Metric
Type
Distance
Auto Bandwidth
Click the Apply button to accept the changes made.
Click the Delete button to delete the specified entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
After clicking the Process ID link (1) in the table, the following page will appear.
Click the OK button to close the window and return to the previous window.
OSPFv3 Passive Interface Settings
This window is used to display and configure the OSPFv3 passive interface settings. If an interface is passive, the
OSPF routing update packets are not sent or received through the specified interface.
Description
Enter the default metric value for the OSPF process here. The range is from 1 to
16777214. By default, this value is 20. This value is used in conjunction with the
OSPFv3 redistribution feature to enable the current routing protocol to use the
same metric value for all redistributed routes. A default metric helps solve the
problem of redistributing routes with incompatible metrics. Whenever the metrics
don't convert directly, using a default metric provides a reasonable substitute and
enables the redistribution to proceed.
Select the distance type here. Options to choose from are Intra-Area, Inter-Area,
and External.
• Intra-Area - Specifies the distance for OSPF intra-area routes.
• Inter-Area - Specifies the distance for OSPF inter-area routes.
• External - Specifies the distance for OSPF external routes.
Enter the distance value for the OSPF process here. The range is from 1 to 254.
By default, this value is 110 for all OSPF routes.
Enter the auto-bandwidth value here. This feature is used to control the reference
value IPv6 OSPF uses when calculating metrics for interfaces. The range is from
1 to 4294967.
Figure 6-80 OSPFv3 Process Settings (Process ID) Window
269