Figure 7-24 shows the output from this command.
ppp 1
Outgoing Interface: eth 0/1
Outgoing Interface MAC Address: 00:A0:C8:00:85:20
Access-Concentrator Name Requested: FIRST VALID
Access-Concentrator Name Received: 13021109813703-LRVLGSROS20W_IFITL
Access-Concentrator MAC Address: 00:10:67:00:1D:B8
Session Id: 64508
Service Name Requested: ANY
Service Name Available:
PPPoE Client State: Bound (3)
Redial retries: unlimited
Redial delay: 10 seconds
Figure 7-24. Viewing PPPoE Settings
Clear a PPPoE Connection
If you are having problems with a PPPoE connection or if you need to change
some configurations for the connection, you can clear the connection. From
the enable mode context, enter:
Syntax: clear pppoe <interface id>
Replace <interface id> with the number of the PPP interface that you bound
to the ATM subinterface. For example, if you bound the PPP 3 interface to the
ATM subinterface, enter:
ProCurve# clear pppoe 3
debug pppoe client Command
You can display all events related to the PPPoE client in real-time. From the
enable mode context, enter:
Syntax: debug pppoe client
Troubleshooting the PPP Link Establishment Process
If you are using PPPoE or PPPoA, you must ensure that the PPP session is
established. From the enable mode context, enter:
Syntax: show interfaces ppp <interface number>
ADSL WAN Connections
Troubleshooting the ADSL Connection
7-53