Setting The Keepalive Interval; Configuring The Timeout Interval For Rtp Streams - HP FlexNetwork MSR Series Configuration Manual

Step
2. Enter voice view.
3. Enter voice dial program
view.
4. Create a VoIP voice entity
and enter VoIP voice entity
view.
5. Set the operating mode of
the jitter buffer to adaptive.
6. Set the operating
parameters for the jitter
buffer that operates in the
adaptive mode.

Setting the keepalive interval

With the keepalive function enabled, if the next destination of the VoIP voice entity is reachable, the
VoIP voice entity is set to available. Otherwise, the VoIP voice entity is set to unavailable.
If the keepalive function is disabled, the system considers the VoIP voice entity is available by
default.
To set the keepalive interval:
Step
1. Enter system view.
2. Enter voice view.
3. Enter voice dial program
view.
4. Create a VoIP voice entity
and enter VoIP voice entity
view.
5. Set the keepalive interval.

Configuring the timeout interval for RTP streams

If the device does not receive any RTP packets during the specified timeout interval, it will disconnect
the established IP call connections.
To configure the timeout interval for RTP streams:
Step
1. Enter system view.
2. Enter voice view.
Command
voice-setup
dial-program
entity entity-number voip
jitter-buffer mode adaptive
jitter-buffer delay { initial
milliseconds | maximum
milliseconds }
Command
system-view
voice-setup
dial-program
entity entity-number voip
keepalive [ interval seconds ]
Command
system-view
voice-setup
20
Remarks
N/A
N/A
N/A
Optional.
By default, the adaptive mode is
disabled and the voice packets
are not buffered.
Optional.
By default, the initial buffering
time is 30 milliseconds and the
maximum buffering time is 160
milliseconds.
Remarks
N/A
N/A
N/A
N/A
Optional.
By default, keepalive function is
disabled.
Remarks
N/A
N/A