Flow-Interval - HP 6600 Command Reference Manual

Default
The value of J0 and J1 bytes is all 0s.
Views
Ten-GigabitEthernet interface view
Default command level
2: System level
Parameters
j0: Sets the regenerator section trace byte.
j1: Sets the path trace byte.
value: Specifies the value for the J0 or J1 byte, a string of 1 to 15 characters.
Usage guidelines
This command is configurable only when the 10-GE interface is operating in WAN mode.
Examples
# Set J0 bytes in SDH frames to Sysname on interface Ten-GigabitEthernet 4/1/1.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 4/1/1
[Sysname-Ten-GigabitEthernet4/1/1] port-mode wan
[Sysname-Ten-GigabitEthernet4/1/1] flag j0 sdh Sysname
Related commands
port-mode

flow-interval

Use flow-interval to set the interface statistics polling interval.
Use undo flow-interval to restore the default interval.
Syntax
flow-interval interval
undo flow-interval
Default
The interface statistics polling interval is 300 seconds.
Views
System view
Default command level
2: System level
Parameters
interval: Sets the statistics polling interval, in seconds. It is in the range of 5 to 300 and must be a multiple
of 5.
21