Enabling Pim Passive Mode; Enabling Snmp Notifications For Pim - HP VSR1000 Configuration Manual

To enable BFD for PIM:
Step
Enter system view.
1.
Enter interface view.
2.
Enable BFD for PIM.
3.

Enabling PIM passive mode

To guard against PIM hello spoofing, you can enable PIM passive mode on a receiver-side interface.
The PIM passive interface cannot receive or forward PIM protocol messages (excluding register,
register-stop and C-RP-Adv messages), and it acts as the DR on the subnet. In BIDIR-PIM, it also
acts as the DF.
Configuration restrictions and guidelines
When you enable PIM passive mode, follow these restrictions and guidelines:
•
This feature takes effect only when PIM-DM or PIM-SM is enabled on the interface.
•
To avoid duplicate multicast data transmission and flow loop, do not enable this feature on a
shared-media LAN with multiple PIM routers.
Configuration procedure
To enable PIM passive mode on an interface:
Step
Enter system view.
1.
Enter interface view.
2.
Enable PIM passive mode on
3.
the interface.

Enabling SNMP notifications for PIM

To report critical PIM events to an NMS, enable SNMP notifications for PIM. For PIM event
notifications to be sent correctly, you must also configure SNMP as described in Network
Management and Monitoring Configuration Guide.
To enable SNMP notifications for PIM:
Step
Enter system view.
1.
Enable SNMP notifications
2.
for PIM.
Command
system-view
interface interface-type
interface-number
pim bfd enable
Command
system-view
interface interface-type
interface-number
pim passive
Command
system-view
snmp-agent trap enable pim
[ candidate-bsr-win-election |
elected-bsr-lost-election |
neighbor-loss ] *
110
Remarks
N/A
N/A
By default, BFD is disabled for
PIM.
Remarks
N/A
N/A
By default, PIM passive mode is
disabled on an interface.
Remarks
N/A
By default, SNMP notifications for
PIM are enabled.