Configuring Sip Authentication Information - HP FlexNetwork MSR Series Configuration Manual

Configuring SIP authentication information

SIP authentication information is required in the following two cases:
•
UAs use a proxy server and the proxy server needs to authenticate UAs.
•
The peer SIP device needs to authenticate the local device during SIP message exchange.
Authentication information selection rule
If the authentication information is configured with the user command, POTS entity view is preferred.
Otherwise, the authentication information configured in SIP client view is used.
If realm is configured on a SIP UA, make sure the value is the same as that configured on the server.
Otherwise, the SIP UA will fail the authentication due to mismatch. If realm is not configured on the
SIP UA, the SIP UA will perform no realm match and consider that the value of realm configured on
the server is trusted.
If it is necessary to configure authentication information in POTS entity view or IVR entity view, the
same authentication information is recommended for the POTS entities or IVR entities configured
with the same telephone number.
IMPORTANT:
In the case of authentication, it is forbidden to execute the user command after the registration
function is enabled because this operation might result in a registration update failure.
The configuration on the SIP server is completed.
Configuration procedure
To configure global SIP authentication information:
Step
1. Enter system view.
2. Enter voice view.
3. Enter SIP client view.
4. Configure global SIP
authentication
information.
To configuring SIP authentication information in POTS or IVR entity view:
Step
1. Enter system view.
2. Enter voice view.
3. Enter voice dial program
view.
4. Enter voice entity view.
5. Configure SIP authentication
information in POTS entity
view or IVR entity view.
Command
system-view
voice-setup
sip
user username password
{ cipher | simple } password
[ cnonce cnonce | realm realm ] *
Command
system-view
voice-setup
dial-program
entity entity-number { ivr | pots }
user username password
{ cipher | simple } password
[ cnonce cnonce | realm realm ] *
140
Remarks
N/A
N/A
N/A
Optional.
By default, the SIP username is
VOICE-GATEWAY and the
authentication password is VOICE-SIP
in SIP client view.
Remarks
N/A
N/A
N/A
N/A
Optional.
By default, no SIP authentication
information is configured in POTS
entity view or IVR entity view.